Tite-Seal™ Self-Adhesive
Waterproof Flashing
for
DOORS, WINDOWS, SKYLIGHTS, SHEATHING PANELS and CHIMNEYS
(Click here to purchase Tite-Seal™ from an online Retailer)
Stop
your Heating and Cooling Dollars from leaking out around your
new windows!
- Keeps Out
Drafts & Moisture
- Eliminates
Expensive Leaks Around Windows, Doors & Skylights
- TS 433 4" X
33'
- TS 4100 4" X
100'
- Available
in 18 unit counter display, and also availbale in mini-pallets
TITE-SEAL™ is
a self-adhesive waterproof flashing material composed of a reinforced
metalized plastic film, with an asphalt mastic adhesive.
DIRECTIONS
FOR USE OF TITE-SEAL™
INTENDED
USE: TITE-SEAL™ is an ideal moisture seal around windows
for both new construction and replacement applications. TITE-SEAL™ can
also be used as an underlayment to seal joints and other openings
under brick, siding, stucco or wood. It can be installed at sills,
heads, chimney shoulders, parapets or anywhere a waterproof seal
is needed.
SURFACE PREPARATIONS: TITE-SEAL™ can
be applied to both vertical and horizontal surfaces including wood,
composition wood panels, metal, vinyl and masonry. The surface
must be clean, dry and free from oil, grease or debris. Dirty,
dusty or weathered surfaces should be primed as necessary, with
a water, polymer, or solvent-based primer to obtain a smooth clean
surface. Some wood composition panels may require priming. TITE-SEAL™ should
be installed when temperatures are 50°F or higher. If applied in
cool weather, the rolls should be stored in a warm place until
needed, and a heat gun used to warm the substrate and overlap.
INSTALLATION: Just
remove the release paper and press in place. TITE-SEAL™ can
be cut with a scissors or utility knife. Roll seams with a hand
roller to ensure uninterrupted contact. To ensure that moisture
flows over the laps, start at the bottom and work up. Side strips
should be installed next and should overlap the bottom strip. The
head of the window should be completed last. Side overlaps should
be 3 inches, and overlaps at the window head should be 6 inches.
WARNING:
- Use caution
to avoid falls when using ladders or scaffolding.
- Test adhesion
with a small piece of TITE-SEAL™. Do not install without
proper adhesion.
- Store in
a cool dry place until ready for use.
- TITE-SEAL™ is
an underlayment sealer and should be protected from long term
ultraviolet exposure.
LIMITED WARRANTY: COFAIR
warrants this product to be of merchantable quality when used and/or
applied in accordance with instructions hereon. COFAIR does not
warrant this product for any purpose or use other than the general
purpose for which it is intended. Liability under this warranty
is limited to the replacement of defective product as purchased.
THIS LIMITED WARRANTY IS ISSUED IN LIEU OF ALL OTHER EXPRESSED
AND IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF FITNESS, AND
EXPRESSLY EXCLUDES LIABILITY FOR CONSEQUENTIAL DAMAGES. |
Tite-Seal™
